Part 1 ` FCC Notes: This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
Part 10 Hold them together with a cable tie. Pass all cables through the cable exit to external connections. SIDE MOUNT UPGRADE KIT Remove the
Part 11 CONNECTING CASH DRAWER (OPTIONAL) The RJ11 connector in I/O area of a XT-3114 system can be used for controlling most of the common cash d
Part 12 POWER ON/OFF Touch Switch Please refer to the previous chapter PRODUCT PICTURE during this part in order to find out the touch switch. A g
Part 13 manual, this switch will always turn the system on when activated, but will not power off the system when tapped again (the forced power off
Part 14 BRIGHTNESS CONTROL In the lower right side of the main unit, there are brightness adjust capacitor tap buttons. Each single tap on th
Part 15 user’s manual ends here. Mouse Emulation When the touch driver is properly installed, this touch panel works exactly like a standard mouse
Part 2 ALERT TO OUR HONORABLE CUSTOMERS: Please always read thoroughly all the instructions and documents delivered with the product before you d
Part 3 INTRODUCTION PRODUCT PICTURES FOR Gen 7 BASE STAND Gen 7 Base Front View Rear View
Part 4 Gen 7 Base PARTS IDENTIFICATION 1. Main Unit 2. LCD touch panel 3. Power indicator 4. Gen 7 base stand 5. Hinge for LCD terminal 6.
Part 5 I/O Plate View A) COM1 (DB9) port B) COM2 (DB9) port C) COM3 (DB9) port D) COM4 (RJ45) port E) USB0~3 port F) LAN1~2 port G) VGA po
Part 6 Various I/O ports supported, including: 1. 4 serial ports with 3 of DB9 connectors and one of 10 pin RJ45 type modular connector. The COM
Part 7 external power source to the set is removed to prevent electric hazard! Never touch any metal pin in the connectors or circuits to avoid high
Part 8 OPENING CABLE COVER Please follow steps sequentially with reference to pictures below to remove the cable cover for Gen 7 slim base models.
Part 9 CONNECTING ALL CABLES To have the re-assembled main unit with stand assembly ready for operation, please connect all required cables to the a
Comments to this Manuals