Posiflex KS-6617Z User Manual download pdf (Page 7)

Part 7

INSTALLATION GUIDES

CAUTION: Before any installation or cable connection to the set, please

always make certain that the system is turned off and the

external power source to the set is removed to prevent electric

hazard! Never touch any metal pin in the connectors or

circuits to avoid high voltage hazard or electrostatic discharge

damage unless the operator is well grounded. Failure to do the

above will void the product warranty!

OPENING CABLE COVER

Please follow steps A to C sequentially with reference to pictures

below to remove the cable cover for Gen 5 slim base models and steps B and C

for Gen 6 super slim base models.

Step A: Push lock/release lever of the Gen 5 slim base for tilt angle adjust

backward. (This operation is not required in Gen 6 super slim base)

Step B: Turn panel to most horizontal position

Step C: Pull at the removal hollow toward the user

Tips: 1. If there is trouble removing the cable cover, try

pressing the arrowed portion of cable cover in the

rear view picture at right at the same time.

2. If there is still trouble removing the cable cover,

don’t force open it. Consult your system

administrator if it has been locked on purpose.

DISCONNECTING ALL CABLES

After removal of the cable cover, the I/O connector area will be

accessible then. Please first note orientations of every existing cable

connection and then disconnect every cable properly before separating the

main unit from the adjustable stand assembly. Please note that the click lock

spring has to be pressed down prior to pulling out the connector such as the

LAN port or the CR port. Please also note that the fixing screws have to be

loosened free prior to disconnection such as the LPT port or COM ports.

Please always hold the connector head instead of pulling on the cable wire

w/ Gen 5 base

w/ Gen 6 base

w/ Gen 5 base

w/ Gen 6 base

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

No comments

Posiflex KS-6617Z User Manual Page 7