Page 1 FCC Notes: This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance
Page 10 below: 1. Hardware power switch 2. Software OFF command 3. Automatic power ON control 4. Emergency power OFF Hardware Power Switch This
Page 11 Emergency Power Off In case of serious system halt due to any reason, the system could fail to be powered off through normal m
Page 12 for this secondary display! The operation range is limited within the primary display area. A program named “Posiflex Touch Terminal
Page 13 performed on a regular basis. Removing Front Cover Please first remove any power and signal connection to this equipment. Please then chec
Page 14 Cleaning for Front Ventilation Use vacuum cleaner to remove any dust or threads accumulation away from both the ventilation ho
Page 15 cover opened, push in the circled spring button in the right picture on both sides of chassis and raise the rear edge o
Page 2 ALERT TO OUR HONORABLE CUSTOMERS: Please always read thoroughly all the instructions and documents delivered with the product
Page 3 application software and development tools that are now inexpensively available and abundant. For the HT-4600(E/X)/PB-4600(E) ser
Page 4 Modem Ring-Up, LAN Or Alarm Wake-Up: The HT-4600(E/X)/PB-4600(E) series can be turned on automatically upon an incoming COM port Modem
Page 5 include serial COM port power supply settings, VGA port power supply setting and DRAM upgrades. All these technical enhancem
Page 6 PCI EXTENSION CARD The PCI extension card is not pre installed; therefore, it is a possibility to add a PCI extension card. However, the
Page 7 SIDE MOUNT UPGRADE KIT (SD-300 Option for HT series) When a side-mount upgrade kit option SD-300 is ordered with the HT-4600(E/X) system
Page 8 instructions is for operating system recovery only if your system integrator does not advise otherwise. For the HT-4600(E/X)/PB-
Page 9 and humidity/moisture. (Operating range 0°C to + 40°C and up to 80% relative humidity – non condensing max. wet bulb 26°C) Pow
Comments to this Manuals