Posiflex PD-2600 User Manual download pdf (Page 8)

Part 8

Fixing pole display base to system

To fix the PD-2602 to base of KS or TP systems, please connect the interface

cable of PD-2602 through the cable exit in base as

in Pix. 9 a peeping view

of pole display joint base

bottom to the appropriate

port in main unit passing

the inside of system base

as indicated in the top-view picture Pix. 10. Match the

pole base (joint mechanism) to the system rear connect

area Fit 2 screws through washers at arrowed points

to hold the joint tight.

INSTALLING PD-2603

Open back cover on system

First push in the circled knobs on

both sides as in Pix. 11 to

remove the back cover.

Remove pole cover

Remove the pole cover on rear edge of the base top

cover of FT system by first removing the 2 arrowed

screws in Pix. 12 and then pushing the wedge shaped

pole cover up.

Install PD and connect interface cable

Insert the base of PD-2603 / PD-2603U from top of

FT system base with the flat side of the pole base

facing the back cover direction and screw back the 2

screws as in Pix. 13. Connect the interface cable to

appropriate port.

COMMAND EMULATION MODE SETUP

Pix. 9

Pix. 10

DIP switch

window

Pix. 14

Pix. 12

Pix. 11

Pix. 13

1 2 3 4 5 6 7 8 9 10 11

No comments

Posiflex PD-2600 User Manual Page 8